The INOVA HIGHTECH MEP 802A / 803A 804A / 805A Autostarter Kit is a great add on for your MEP Generator Set. It will allow remote start with the flip off a switch or it can be connected to an Automatic Transfer Switch.
Please sent us an e-mail for the Installation Manual for the MEP 804A / 805A - Thank you!
The MEP 802A / 803A / 804A / 805A Autostarter has the following features which can be set with the DIP Switch on the Board:
DIP Switch 1: Regular Fuel / Aux Fuel
DIP Switch 2: Warm Up Time 1 min or 5 min (This is the time delay before the Relay "Power On" is activated. This Relay switches the Control Voltage to the 3 Phase Contactor "On" and connect the LOAD to the Generator)
DIP Switch 3: Cool Down 2 min, 6 min or 10 min (This is the time delay after the Relay "Power On" is disengaged, shutting off the Control Voltage to the 3 Phase Contactor removing the LOAD from the Generator and therefor allowing the unit to cool down)
DIP Switch 4: Pre Heat Time determined by ambient air temperature or fixed time (See table below)
DIP Switch 5: Pre Heat Time 15 sec or 45 sec [if DIP Switch 4 is set to fixed time] ( This setting is for the case that the Generator is operated in a controlled environment i.e. Building, Garage etc)
The Autostarter will automatically shut down and display a light indicator in the event of a Oil Pressure or Overheat situation, preventing the Generator Set from automatically restarting. The Autostarter can easily be reset, once the issues of leading to Low Oil Pressure or Overheat situation have been fixed.
The installation is not very difficult for the do it your self-er.
The MEP 802A / 803A / 804A / 805A Autostarter KIT includes:
1. MEP 802A / 803A / 804A / 805A Autostarter Circuit Board
2. MIL-I-46058C Conformal Coating
3. Drill / Mounting Templates
4. Detailed Installation Manual
5. 24 feet 16ga standard multi stranded SXL wire, strong resistance to moisture, solvents and prolonged high heat -
Thick wall special purpose automotive wire is insulated with chemically cross-linked polyethylene. Withstands prolonged temperatures of up to 257°F
6. Mounting Hardware [Stainless Steel Phillips Pan Head Machine Screws #6-32x0.75", Stainless Steel #6-32 Nuts as Spacers, Stainless Steel #6-32 K-Lock Nut's]
7. Crimp On Fork and Ring Lugs
8. Wiring Diagram
9. A 60 Day Money Back Guarantee
10. 1 Year Limited Warranty
Not included in this KIT:
4 Pole Receptacle
4 Pole Connector with 16 ga wire
Photos of MEP 802A Installation are courtesy of Mr. Steve Marquess, Maryland
You can purchase these item separate or you may have them already. We have recommended the above items in our manual with manufacturer part number.
Up dated Videos:
Simulated Low Oil Pressure PART 1
Simulated Low Oil Pressure PART 2