THIS KIT IS ONLY AVAILABLE FOR PURCHASE THROUGH ACTIVE MILITARY PROCUREMENT OR SALE TO FEDERAL, STATE and MUNICIPAL ENTITIES with a VALID and ACTIVE CAGE Number ONLY! PLEASE USE YOUR LEVEL2 or LEVEL3 Government issued Credit Card when purachsing this KIT ONLINE!
The INOVA HIGHTECH MEP 805B / 806B Autostarter Kit is a great add on for your MEP Generator Set. It will allow remote start with the flip off a switch or it can be connected to an Automatic Transfer Switch.
The MEP 805B / 806B Autostarter has the following features which can be set with the DIP Switch on the Board:
DIP Switch 1: Regular Fuel / Aux Fuel
DIP Switch 2: Warm Up Time 1 min or 5 min
DIP Switch 3: Cool Down 4 min, 12 min or 30 min
DIP Switch 4: Not Used
DIP Switch 5: Not used
The 805B/806B Software affects/changes the following functions / Terminal Nomenclature:
1. Dip Switch Functions, Settings and Timing
2. Different Connections between the Board and the Cubicle
3. No external Contactor needed [utilizing internal K1 Contactor]
4. No Pre Heat - No Ether Injection
5. Fault Reset for 3 seconds
6. No ambient temperature dependent timing
7. Oil Pressure Input is connected to Relay K15 Terminal B and will stop Cranking the Engine when this Input goes low.
Maximum Crank Time is 15 seconds - if engine RPM Sensor does not detect a running engine within 15seconds then the
unit will go into fault mode indicated by a blinking LED AUX Fuel. Reset by pulling the DC Breaker on your Genset for
about 5 seconds.
The installation is not very difficult for the do it your self-er.
The MEP 805B / 806B Autostarter KIT includes:
1. MEP 805B / 806B Autostarter Circuit Board
2. MIL-I-46058C Conformal Coating
3. Drill / Mounting Templates
4. Detailed Installation Manual
5. 24 feet 16ga standard multi stranded SXL wire, strong resistance to moisture, solvents and prolonged high heat -
Thick wall special purpose automotive wire is insulated with chemically cross-linked polyethylene. Withstands prolonged temperatures of up to 257°F
6. Mounting Hardware [Stainless Steel Phillips Pan Head Machine Screws #6-32x0.75", Stainless Steel #6-32 Nuts as Spacers, Stainless Steel #6-32 K-Lock Nut's]
7. Crimp On Fork and Ring Lugs
8. Wiring Diagram
9. A 60 Day Money Back Guarantee
10. 1 Year Limited Warranty
Not included in this KIT:
4 Pole Receptacle
4 Pole Connector with 16 ga wire
You can purchase these item separate or you may have them already. We have recommended the above items in our manual with manufacturer part number.