MEP ATS Controller

MEP ATS Controller
MEP ATS Controller
Product Code: MEP ATS
Availability: In Stock
Price: $346.45
Qty:     - OR -   Add to Wish List
Add to Compare

MEP Generator Transfer System Controller

This INOVA HIGHTECH Ltd. Kit allows you to Monitor your Main Power Lines (Single Phase 240 VAC) and if the Power goes out, will start your MEP Generator (or any other two wire Start Generator) in a power outage. Once Generator Power becomes available the Unit will then initiate the Power Transfer. This can either be done with two large size Contactors if you prefer to built your own ATS or with a regular ATS in the case your ATS does not have a Control Board built in.

The following Delays / Functions can be selected with the DIP Switches:

MAIN Power Out Detection:

Dip Switch 1 and Dip Switch 2

15 seconds (Default), 30 seconds, 45 seconds, 60 seconds

If Main Power is not restored during the selected delay time then this system wil activate the Start/Run Relay to start / run your Generator

Generator Power On Delay:

Dip Switch 3 and Dip Switch 4

15 seconds (Default), 30 seconds, 45 seconds, 60 seconds

Once the Generator has started and gone through it's warm up phase and makes the Power Output available then this time delay will start to provide an additional stabilization time for the system.

Transfer Activation:

Dip Switch 5

ON for entire duration (default) or 15 seconds one time activation

The System will now intitate the actual Transfer and backup power becomes available. As soon as Main Power comes back ON both Relays for Start/Run and Transfer (if default is selected) will immdeiatly shut off and the the system will go back into standby for the next power outage. The Generator will enter it's Cool Down Phase and then shutoff


Installation Manual MEP ATS







Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Powered By OpenCart